MAC Address Click

MAC Address click provides a unique node address for your application. It also has 1Kbit of writable EEPROM memory. MAC Address click carries the 24AA025E64 2K I2C Serial EEPROM with EUI-64™ node identity. The click is designed to run on either 3.3V or 5V power supply. MAC Address click communicates with the target microcontroller over I2C interface.

24AA025E64 features

The Microchip Technology Inc. 24AA025E64 is a 2Kb Serial EEPROM with a pre-programmed IEEE EUI-64 MAC Address. The device is organized as two blocks of 128 x 8-bit memory with a 2-wire serial interface. Low voltage design permits operation down to 1.7V, with maximum standby and active currents of only 1 uA and 1 mA, respectively. The 24AA025E64 also has a page write capability for up to sixteen bytes of data.

Specifications

Pinout diagram

This table shows how the pinout on MAC Address click corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns).

Notes	Pin					Pin	Notes
	NC	1	AN	PWM	16	NC
	NC	2	RST	INT	15	NC
	NC	3	CS	TX	14	NC
	NC	4	SCK	RX	13	NC
	NC	5	MISO	SCL	12	SCL	I2C clock
	NC	6	MOSI	SDA	11	SDA	I2C data
Power supply	+3.3V	7	3.3V	5V	10	+5V	Power supply
Ground	GND	8	GND	GND	9	GND	Ground

Jumpers and settings

Programming

Code examples for MAC Address click, written for MikroElektronika hardware and compilers are available on Libstock.

Code snippet

The following code reads one byte from EEPROM and transmits data to UART.

01 if( !MACADDRESS_readByte( loop, &read ) )
02 {
03     LOG( "rn Byte value [ " );
04     ByteToHex( read, txt );
05     Ltrim( txt );
06     LOG( txt );
07     LOG( " ] succeessfully read from [ " );
08     ByteToHex( loop, txt );
09     Ltrim( txt );
10     LOG( txt );
11     LOG( " ] address" );
12 }
13 else
14 {
15     LOG( "rn Read Byte Error" );
16 }
17 }